Changes for page LSS Mechanical
Last modified by Eric Nantel on 2024/07/12 11:24
Change comment: There is no comment for this version
Summary
-
Page properties (2 modified, 0 added, 0 removed)
-
Attachments (0 modified, 0 added, 2 removed)
Details
- Page properties
-
- Author
-
... ... @@ -1,1 +1,1 @@ 1 -xwiki:XWiki. CBenson1 +xwiki:XWiki.ENantel - Content
-
... ... @@ -66,9 +66,16 @@ 66 66 |[[image:LSS-Bottom-Inserts(800px).png||width="400"]]|The bottom case of the servo includes 16x 2-56 threaded inserts plus two M3 threaded inserts located at the center of the SES pattern. 67 67 |[[image:LSS-Screws-Distance.png]]|IMPORTANT NOTE: ONLY USE THE 2-56 x 14” SCREWS PROVIDED. LONGER SCREWS CAN AND WILL CAUSE DAMAGE TO THE SERVO. 68 68 69 -= Dimensions=69 += SES Pattern = 70 70 71 -|(% style="width:350px" %)[[image:LSS-Dimensions-01.png]]| 72 -|[[image:LSS-Dimensions-02.png]]| 71 +The SES mounting pattern is based on two holes which are used for mounting objects to a Hitec standard servo horn such as the Hitec HS-422. The mounting pattern involves: 73 73 73 +|(% style="width:350px" %)[[image:SES-V2 - SES Pattern (4).png||width="200"]]|((( 74 +* 8mm diameter center hole 75 +* Four equally spaced holes located on a 0.656” diameter circle. Sometimes these four holes are threaded 2-56 (imperial), sometimes they are not 76 +* Outer diameter is 1” (2.54cm) 77 +))) 78 +|[[image:SES-V2 - SES Pattern (8).png||width="200"]]|Newer brackets have four additional holes (for a total of eight holes) spaced at 45 degrees to allow for easy mounting. 79 + 80 + 74 74
- LSS-Dimensions-01.png
-
- Author
-
... ... @@ -1,1 +1,0 @@ 1 -xwiki:XWiki.ENantel - Size
-
... ... @@ -1,1 +1,0 @@ 1 -31.2 KB - Content
- LSS-Dimensions-02.png
-
- Author
-
... ... @@ -1,1 +1,0 @@ 1 -xwiki:XWiki.ENantel - Size
-
... ... @@ -1,1 +1,0 @@ 1 -79.0 KB - Content