Changes for page LSS Mechanical
Last modified by Eric Nantel on 2024/07/12 11:24
Change comment: There is no comment for this version
Summary
-
Page properties (2 modified, 0 added, 0 removed)
-
Attachments (0 modified, 2 added, 1 removed)
Details
- Page properties
-
- Author
-
... ... @@ -1,1 +1,1 @@ 1 -xwiki:XWiki. ENantel1 +xwiki:XWiki.CBenson - Content
-
... ... @@ -1,5 +1,5 @@ 1 1 (% class="wikigeneratedid" id="HTableofContents" %) 2 -** Page Contents**2 +**Table of Contents** 3 3 4 4 {{toc depth="3"/}} 5 5 ... ... @@ -9,11 +9,11 @@ 9 9 == Spline == 10 10 ))) 11 11 |(% style="width:350px" %)[[image:LSS - Splines.png||width="400"]]|((( 12 -The spline allows the driv inghorn to be connected to the output shaft so that it rotates with the shaft. The24 toothspline selected is used by other servo manufacturers(for example Hitec's HS-422 andHS-645MG RC servos)and as such there are a variety of accessories / horns which are compatible and can be installed on the servo. Alternatives to using the Lynxmotion driving horn include a wheel, a pulley or sprocket, a tubing connector, specific RC horns and more. Note that there are many different spline cross sections, and in order to ensure the a horn can fit onto the output shaft of the servo, it must have the matching / identical spline.12 +The spline allows the driven horn to be connected to the output shaft so that it rotates with the shaft. The spline selected is used by other servo manufacturers and as such there are a variety of accessories / horns which are compatible and can be installed on the servo. Alternatives to using the Lynxmotion driving horn include a wheel, a pulley or sprocket, a tubing connector, specific RC horns and more. Note that there are many different spline cross sections, and in order to ensure the a horn can fit onto the output shaft of the servo, it must have the matching / identical spline. 13 13 14 14 Although the final gear which (located within the servo) which is connected to the output spline is supported by two radial ball bearings, the output spline is intended to withstand torque as opposed to radial or axial loads. 15 15 16 -Learn more about [[SES-Gearing & Horns>>doc:Servo Erector Set (SES) Building System.SES - Parts.SES - Gearing Information.WebHome]]16 +Learn more about SES Gearing & Horns 17 17 ))) 18 18 |(% colspan="2" style="width:350px" %)((( 19 19 == Case ==
- LSS-Front-Dimensions.png
-
- Author
-
... ... @@ -1,1 +1,0 @@ 1 -xwiki:XWiki.ENantel - Size
-
... ... @@ -1,1 +1,0 @@ 1 -115.7 KB - Content
- LSS - driven horn.png
-
- Author
-
... ... @@ -1,0 +1,1 @@ 1 +xwiki:XWiki.CBenson - Size
-
... ... @@ -1,0 +1,1 @@ 1 +54.7 KB - Content
- LSS - idler.png
-
- Author
-
... ... @@ -1,0 +1,1 @@ 1 +xwiki:XWiki.CBenson - Size
-
... ... @@ -1,0 +1,1 @@ 1 +64.8 KB - Content