Summary

• Page properties (1 modified, 0 added, 0 removed)

Details

Page properties

Content

...	...	@@ -11,7 +11,7 @@
11	11
12	12	= Lynxmotion Smart Servo (LSS) RC Modes =
13	13
14		-All three Lynxmotion Smart Servo motors can be used with normal hobby remote control (RC) electronics including handheld remote controls and RC servo controllers. Unlike normal RC servo motors however, the Lynxmotion servo's configurations can be changed via programming. There are two methods to change from serial to RC mode: via the [[LSS - Button Menu>>doc:lynxmotion-smart-servo.lss-button-menu.WebHome||style="background-color: rgb(255, 255, 255);"]] or sending a CRC command (explained on the [[communication protocol>>doc:lynxmotion-smart-servo.lss-communication-protocol.WebHome]] page). Note: Each mode can have the rotation reversed, but clockwise is standard (equivalent to CW1 or CW-1 commands). The motion controller used in serial mode is not the same as the motion controller use in RC mode. RC mode is intended to add functionality to what would be considered "normal" RC behavior based on PWM input.
	14	+All three Lynxmotion Smart Servo motors can be used with normal hobby remote control (RC) electronics including handheld remote controls and RC servo controllers. Unlike normal RC servo motors however, the Lynxmotion servo's configurations can be changed via programming. There are two methods to change from serial to RC mode: via the [[LSS - Button Menu>>doc:ses-v2.lynxmotion-smart-servo.lss-button-menu.WebHome||style="background-color: rgb(255, 255, 255);"]] or sending a CRC command (explained on the [[communication protocol>>doc:lynxmotion-smart-servo.lss-communication-protocol.WebHome]] page). Note: Each mode can have the rotation reversed, but clockwise is standard (equivalent to CW1 or CW-1 commands). The motion controller used in serial mode is not the same as the motion controller use in RC mode. RC mode is intended to add functionality to what would be considered "normal" RC behavior based on PWM input.
15	15
16	16	== 180° Mode ==
17	17
...	...	@@ -71,4 +71,4 @@
71	71
72	72	**Important note **
73	73
74		-To revert from RC mode back to serial mode, the [[LSS - Button Menu>>doc:lynxmotion-smart-servo.lss-button-menu.WebHome]] is required. Should the button be inaccessible (or broken) when the servo is in RC mode and the user needs to change to serial mode, a 5V constant HIGH needs to be sent to the servo's Rx pin (RC PWM pin) with a common GND and wait for over 30 seconds. Normal RC PWM pulses should not exceed 2500 milliseconds. After 30 seconds, the servo will interpret this as a desired mode change and change to serial mode. This has been implemented as a fail safe.
	74	+To revert from RC mode back to serial mode, the [[LSS - Button Menu>>doc:ses-v2.lynxmotion-smart-servo.lss-button-menu.WebHome]] is required. Should the button be inaccessible (or broken) when the servo is in RC mode and the user needs to change to serial mode, a 5V constant HIGH needs to be sent to the servo's Rx pin (RC PWM pin) with a common GND and wait for over 30 seconds. Normal RC PWM pulses should not exceed 2500 milliseconds. After 30 seconds, the servo will interpret this as a desired mode change and change to serial mode. This has been implemented as a fail safe.