Summary

• Page properties (3 modified, 0 added, 0 removed)

Details

Page properties

Title

...	...	@@ -1,1 +1,1 @@
1		-ses-v2-wiring
	1	+SES - Wiring

Parent

...	...	@@ -1,1 +1,1 @@
1		-ses-v2.ses-v2-system.WebHome
	1	+ses-v2.ses-v2-system.ses-v2-info.WebHome

Content

...	...	@@ -6,13 +6,13 @@
6	6	* RC Connector: 3-Pin 2.54mm (0.1") spaced JR connector: GND (black); V (red); Signal (yellow); Extra (green) 2.54" (0.1") single pin JR connector from servo Tx pin.
7	7	* LSS Serial Cable: 24 AWG multi-strand, flat ribbon, silicon covered.
8	8
9		-For more information regarding the pinout, how to connect the servos and the LSS servo's electronics, refer to the [[LSS - Electrical>>doc:ses-v2.lynxmotion-smart-servo.lss-electrical.WebHome]] page. When purchasing Lynxmotion serial cables, the user does not need to worry about any modifications as all the pins and wires are correct, however, should the LSS be connected to non-Lynxmotion products such as a microcontroller, be certain to understand the pinout before making any connections.
	9	+For more information regarding the pinout, how to connect the servos and the LSS servo's electronics, refer to the [[LSS - Electrical>>doc:lynxmotion-smart-servo.lss-electrical.WebHome]] page. When purchasing Lynxmotion serial cables, the user does not need to worry about any modifications as all the pins and wires are correct, however, should the LSS be connected to non-Lynxmotion products such as a microcontroller, be certain to understand the pinout before making any connections.
10	10
11	11	**Wire Routing**
12	12
13	13	In a robotic creation, keeping the wires as clean as possible helps ensure they do not get snagged internally or externally. Many V2 brackets include slots where plastic cable clips can be installed in order to more cleanly and securely rout wires. When wiring a custom robotic creation, ensure there is enough slack in the wires to allow for the full range of motion at each joint, and so they do not get snagged. Each clip only allows passage of one 4-wire cable.
14	14
15		-[[doc:ses-v2.ses-v2-system.ses-v2-wiring.ses-wiring-information-cable-clips.WebHome]]
	15	+[[doc:ses-v2-system.ses-v2-info.ses-wiring-information.ses-wiring-information-cable-clips.WebHome]]
16	16
17	17	|(% style="width:350px" %)**Typical Routing**|
18	18	|(% style="width:350px" %){{lightbox image="CC-01-Example.png"/}}|