Stomper Sumo Sensor Assembly Instructions

Last modified by Eric Nantel on 2023/02/02 14:30

Stomper Online Assembly Instructions.


Safety first! Wear eye protection and never touch a powered robot!

1. Line Detectors

We've included the hardware to install two Single Line Detector units on the Stomper chassis. Push one 4-40 x 5/8" screw through the hole in the scoop. Then thread a washer onto the screw, followed by the sensor. Use a nylon insert nut to hold the sensor in place. Do the same for both sides.

Note: Single Line Detector units sold separately.

2 x  2 x  2 x 

Figure 1.
Created by Eric Nantel on 2023/02/02 14:24
Copyright RobotShop 2018