Wiki source code of LSS Configuration Software - Configure IDs
Version 35.1 by Eric Nantel on 2019/05/22 11:15
Show last authors
| 1 | **Page Contents** |
| 2 | |
| 3 | {{toc/}} |
| 4 | |
| 5 | = What's Needed = |
| 6 | |
| 7 | (% style="max-width:750px" %) |
| 8 | |(% style="width:125px" %)[[LSS Servo>>doc:servo-erector-set-system.ses-servos.ses-lynxmotion-smart-servo.WebHome]]|(% style="width:125px" %)[[Adapter Board>>doc:servo-erector-set-system.ses-electronics.ses-modules.lss-adapter-board.WebHome]]|(% style="width:125px" %)[[Wall Adapters>>doc:servo-erector-set-system.ses-electronics.ses-wall-adapters.WebHome]]|(% style="width:125px" %)[[USB Cable>>doc:servo-erector-set-system.ses-electronics.ses-wiring.WebHome]]|(% style="width:125px" %) |(% style="width:125px" %) |
| 9 | |[[image:servo-erector-set-system.ses-servos.ses-lynxmotion-smart-servo.WebHome@LSS-Servo.PNG]]|[[image:servo-erector-set-system.ses-electronics.ses-modules.lss-adapter-board.WebHome@LSS-ADA.png]]|[[image:servo-erector-set-system.ses-electronics.ses-wall-adapters.WebHome@RB-Hap-05.png]]|[[image:servo-erector-set-system.ses-electronics.ses-wiring.WebHome@USB-Cable-A-Mini.PNG]]| | |
| 10 | |
| 11 | = Set or Change IDs = |
| 12 | |
| 13 | |(% style="width:350px" %){{lightbox image="LSS-Config-IDs-Switch.PNG"/}}|Set LSS Adapter to USB mode |
| 14 | |{{lightbox image="LSS-Config-IDs-USB-Power.PNG"/}}|Connect the Supply & USB to the Adapter |
| 15 | |{{lightbox image="LSS-Config-IDs-LSS.PNG"/}}|Connect your LSS Servo to the Adapter |
| 16 | |{{lightbox image="LSS-Config-IDs-Config.png"/}}|Open the LSS Config |
| 17 | |(% style="text-align:center" %){{lightbox image="LSS-Config-IDs-Connect"/}}|Select your COM port and click "connect" and all the parameters should now be enabled |
| 18 | |{{lightbox image="LSS-Config-IDs-ID.png"/}}|Set the servo ID & Update |
| 19 | |{{lightbox image="a"/}}|Apply a post-it |
| 20 | |{{lightbox image="a"/}}|Next servo / to Step 2 |