LSS Configuration Software - Configure IDs

Version 37.1 by Eric Nantel on 2019/05/30 08:38

Page Contents

What's Needed

LSS Servo	Adapter Board	Wall Adapters	USB Cable

	On your LSS adapter board select the "USB" mode for a direct serial communication between your computer and the LSS
	Connect your USB cable to both your computer and the LSS adapter board.
	Connect your LSS Servo to the Adapter
	Open the LSS Config
	Select your COM port and click "connect" and all the parameters should now be enabled
	Set the servo ID & Update
	Apply a post-it
	Next servo / to Step 2

Tags:

Created by Eric Nantel on 2019/05/22 11:14