The LSS Configuration software is intended to provide easy access to the main features and functionality of the Lynxmotion Smart Servo Motors, as well as providing access to firmware updates.

NOTE: Only one servo should be connected to the software at any time. The servo must be powered correctly and in serial mode. Should your servo NOT be in serial mode, please refer to the button menu page.

Connection

Connection to the servo is done automatically, via any properly installed USB to serial interface like the LSS Adapter board. Ensure the board is recognized by the computer and if not, install the proper drivers. The software automatically scans all standard baud rates using ID254 (broadcast ID) and waits for a reply from the servo connected.

Firmware Update

The LSS Config serves as the main software to update the servo's onboard firmware / programming. An internet connection is needed in order for the software to check if an online update is available. 

Servo Control

The servo control section allows you to visually move the servo and change a variety of parameter.

{More to come}

Sensor Graph

The sensor graphing feature of the software allows you to select and display, with respect to time 

{More to come}

Command Line