Summary

• Page properties (1 modified, 0 added, 0 removed)

Details

Page properties

Content

...	...	@@ -6,16 +6,6 @@
6	6
7	7	Connection to the servo is done automatically, via any properly installed USB to serial interface like the [[LSS Adapter board>>doc:LSS - Overview (DEV).LSS - Adapter Board.WebHome]]. Ensure the board is recognized by the computer and if not, install the proper drivers. The software automatically scans all standard baud rates using ID254 (broadcast ID) and waits for a reply from the servo connected.
8	8
9		-= Configurations =
10		-
11		-Upon connection, the software will read all configuration values and update the "configurations" section.
12		-
13		-Changing the values displayed will update the session.
14		-
15		-UPDATE: Updates all values to EEPROM, changing the configurations
16		-
17		-UNDO ALL: Revert all changes made
18		-
19	19	= Firmware Update =
20	20
21	21	The LSS Config serves as the main software to update the servo's onboard firmware / programming. An internet connection is needed in order for the software to check if an online update is available. Do not disconnect the servo during a firmware update. During the update, a progress bar will be displayed in the command line.
...	...	@@ -24,10 +24,18 @@
24	24
25	25	The servo control section allows you to visually move the servo and change a variety of parameter.
26	26
27		-Servo ID
	17	+The large red STOP button will send a LIMP command to the servo.
28	28
29	29	{More to come}
30	30
	21	+= Configurations =
	22	+
	23	+Upon connection, the software will read all configuration values and update the "configurations" section. Visit the [[LSS Communication Protocol>>doc:LSS - Overview (DEV).LSS - Communication Protocol.WebHome]] page for more information about commands, actions and configurations.
	24	+
	25	+Changing the values displayed will update the session. Pressing the UPDATE button will write all values to EEPROM, changing the configurations.
	26	+
	27	+UNDO ALL: Revert all changes made
	28	+
31	31	= Sensor Graph =
32	32
33	33	The sensor graphing feature of the software allows you to select, display and record, with respect to time, the output from all of the servo's sensors.