Summary

• Page properties (1 modified, 0 added, 0 removed)

Details

Page properties

Content

...	...	@@ -1,19 +1,31 @@
1		-The LSS Configuration software is intended to provide easy access to the main features and functionality of the Lynxmotion Smart Servo Motors, as well as providing access to firmware updates.
	1	+The LSS Configuration software is intended to provide easy access to the main features and functionality of the [[Lynxmotion Smart Servo Motors>>doc:LSS - Overview (DEV).WebHome]], as well as providing access to firmware updates.
2	2
3		-NOTE: Only one servo should be connected to the software at any time. The servo must be powered correctly and in serial mode. Should your servo NOT be in serial mode, please refer to the button menu page.
	3	+NOTE: Only one servo should be connected to the software at any time. The servo must be powered correctly and in serial mode. Should your servo NOT be in serial mode, please refer to the [[button menu>>doc:LSS - Overview (DEV).LSS - Button Menu.WebHome]].
4	4
5	5	= Connection =
6	6
7		-Connection to the servo is done automatically, via any properly installed USB to serial interface like the LSS Adapter board. Ensure the board is recognized by the computer and if not, install the proper drivers. The software automatically scans all standard baud rates using ID254 (broadcast ID) and waits for a reply from the servo connected.
	7	+Connection to the servo is done automatically, via any properly installed USB to serial interface like the [[LSS Adapter board>>doc:LSS - Overview (DEV).LSS - Adapter Board.WebHome]]. Ensure the board is recognized by the computer and if not, install the proper drivers. The software automatically scans all standard baud rates using ID254 (broadcast ID) and waits for a reply from the servo connected.
8	8
	9	+= Configurations =
	10	+
	11	+Upon connection, the software will read all configuration values and update the "configurations" section.
	12	+
	13	+Changing the values displayed will update the session.
	14	+
	15	+UPDATE: Updates all values to EEPROM, changing the configurations
	16	+
	17	+UNDO ALL: Revert all changes made
	18	+
9	9	= Firmware Update =
10	10
11		-The LSS Config serves as the main software to update the servo's onboard firmware / programming. An internet connection is needed in order for the software to check if an online update is available.
	21	+The LSS Config serves as the main software to update the servo's onboard firmware / programming. An internet connection is needed in order for the software to check if an online update is available. Do not disconnect the servo during a firmware update. During the update, a progress bar will be displayed in the command line.
12	12
13	13	= Servo Control =
14	14
15	15	The servo control section allows you to visually move the servo and change a variety of parameter.
16	16
	27	+Servo ID
	28	+
17	17	{More to come}
18	18
19	19	= Sensor Graph =