Changes for page MES - Power Distribution Board (PDB)

Last modified by Eric Nantel on 2021/09/24 09:36

From version < 209.1 >

edited by Brahim Daouas
on 2018/06/18 13:22

To version < 210.1 >

edited by Brahim Daouas
on 2018/06/18 13:25

< >

Change comment: There is no comment for this version

Summary

Page properties

Content

@@ -120,4
          +120,4 @@
  == Safety ==
--{{warningBox warningText="Warning: Ensure the positive and negative battery leads do not contact each other<br/><br/>Warning: Ensure to connect the battery LAST<br/><br/>Warning: Pay attention to not short positive and negative bullet connectors accidently when the PDB is powered<br/><br/>Warning: Ensure the current draw from all motors does not exceed the maximum discharge current of the battery nor the PDB current rating<br/><br/>Warning: Ensure that JA jumper is not inserted if a 5V external regulator is soldered on the PDB<br/><br/>Warning: Verify the Vout jumper position before powering an external device through D32 and Vout"/}}
++{{warningBox warningText="Warning: Ensure the positive and negative battery leads do not contact each other<br/><br/>Warning: Double check the polarity of the XT60 battery wires and ESCs power leads<br/><br/>Warning: Ensure to connect the battery LAST<br/><br/>Warning: Pay attention to not short positive and negative bullet connectors accidently when the PDB is powered<br/><br/>Warning: Ensure the current draw from all motors does not exceed the maximum discharge current of the battery nor the PDB current rating<br/><br/>Warning: Ensure that JA jumper is not inserted if a 5V external regulator is soldered on the PDB<br/><br/>Warning: Verify the Vout jumper position before powering an external device through D32 and Vout"/}}