Changes for page MES - Power Distribution Board (PDB)
Last modified by Eric Nantel on 2021/09/24 09:36
Change comment: There is no comment for this version
Summary
-
Page properties (2 modified, 0 added, 0 removed)
Details
- Page properties
-
- Author
-
... ... @@ -1,1 +1,1 @@ 1 -xwiki:XWiki. ENantel1 +xwiki:XWiki.BDaouas - Content
-
... ... @@ -34,7 +34,7 @@ 34 34 1. DO NOT connect the batteries until everything has been wired and checked. 35 35 1. Verify the polarity of the battery connector(s) and sure the positive (red) lead connects to the top PCB, and the negative / GND (black) lead connects to the bottom PCB. 36 36 1. Should your ESC not use the correct bullet connectors for power, the existing connectors can be removed and replaced by 3.5mm connectors. 37 -1. Connect the ESCs to the PDB based on the configurations below, ensuring the positive is connected to the top pla ce and negative connected to the bottom plate.37 +1. Connect the ESCs to the PDB based on the configurations below, ensuring the positive is connected to the top plate and negative connected to the bottom plate. 38 38 11. For a single battery configuration, the ESCs should be installed close to the battery 39 39 11. For a dual battery configuration, the ESCs should be installed equally on the board to try to lessen uneven current draw between the batteries 40 40 1. Connect the three-pin cables based on your copter configuration below. ... ... @@ -81,8 +81,8 @@ 81 81 |[[image:MES-PDB-Color-Squares-Orange.png||width="15"]]|✓|✓|✓|✓|✓|✓ 82 82 |[[image:MES-PDB-Color-Squares-Green.png||width="15"]]|✓|✓|✓|✓|✓|✓ 83 83 |[[image:MES-PDB-Color-Squares-White.png||width="15"]]| | | | |✓|✓ 84 -|(% colspan="1" rowspan="2" %)[[image:MES-PDB-Wiring-Power.png||width="350"]]|[[image:MES-PDB-Color-Squares-Red.png||width="15"]]|(% colspan="6" rowspan="1" %) 85 -|[[image:MES-PDB-Color-Squares-Black.png||width="15"]]|(% colspan="6" rowspan="1" %) 84 +|(% colspan="1" rowspan="2" %)[[image:MES-PDB-Wiring-Power.png||width="350"]]|[[image:MES-PDB-Color-Squares-Red.png||width="15"]]|(% colspan="6" rowspan="1" %)3.5mm Male Bullet Connector connected to the positive plane 85 +|[[image:MES-PDB-Color-Squares-Black.png||width="15"]]|(% colspan="6" rowspan="1" %)3.5mm Female Bullet Connector connected to the negative plane 86 86 87 87 == Jumpers == 88 88