Changes for page A4WD3-LED Board
Last modified by Eric Nantel on 2022/08/30 08:56
Change comment: There is no comment for this version
Summary
-
Page properties (1 modified, 0 added, 0 removed)
Details
- Page properties
-
- Content
-
... ... @@ -22,7 +22,7 @@ 22 22 * 1x central white CREE LED (JR5050BWT) 23 23 * 8x Red 0630 LEDs 24 24 * Onboard voltage regulation 25 -* Operating voltage: ~_~_min~_~__max~_~__nominal25 +* Operating voltage: 10.5V min / 23V max 26 26 * Current (white) : ~_~_~_~_ mA (red) ~_~_~_~__ mA 27 27 28 28 ))) ... ... @@ -30,16 +30,24 @@ 30 30 ((( 31 31 = Pinout = 32 32 33 -|(% rowspan="7" style="text-align:center; vertical-align:middle; width:350px" %){{lightbox image=" LSS-LED-PinOUt.png"/}}|(% style="text-align:center; vertical-align:middle; width:35px" %)[[image:[email protected]]]|(% style="vertical-align:middle" %)(((34 -**Positive VIN**:Voltage Input33 +|(% rowspan="7" style="text-align:center; vertical-align:middle; width:350px" %){{lightbox image="A4WD3-LED-Pinout.png"/}}|(% style="text-align:center; vertical-align:middle; width:35px" %)[[image:[email protected]]]|(% style="vertical-align:middle" %)((( 34 +**Positive**: Positive voltage Input 35 35 ))) 36 -|(% style="vertical-align:middle" %)[[image:[email protected]]]|(% style="vertical-align:middle" %)**Ground (0V):36 +|(% style="vertical-align:middle" %)[[image:[email protected]]]|(% style="vertical-align:middle" %)**Ground:** Negative voltage Input 37 37 |(% style="vertical-align:middle" %)[[image:[email protected]]]|(% style="vertical-align:middle" %)((( 38 -** LSSConnectors:**38 +**Ground:** Negative connection point to be used when a microcontroller control the LED's to be at the same potential. 39 39 ))) 40 -|(% style="vertical-align:middle" %)[[image:[email protected]]]|(% style="vertical-align:middle" %) 41 - |(%style="vertical-align:middle" %)[[image:lynxmotion-wiki-attachments.WebHome@SQUARE-Green.png]]|(% style="vertical-align:middle" %)40 +|(% style="vertical-align:middle" %)[[image:lynxmotion-wiki-attachments.WebHome@SQUARE-Green.png||alt="SQUARE-Yellow.png"]]|(% style="vertical-align:middle" %)((( 41 +**H1 Jumper:** 42 42 43 +* Place a jumper between "S" & "+" to trigger ON the CREE White LED 44 + 45 +OR 46 + 47 +* Connect this to any source 48 +))) 49 +|(% style="vertical-align:middle" %)[[image:[email protected]||alt="SQUARE-Green.png"]]|(% style="vertical-align:middle" %)**H2 Jumper:** 50 + 43 43 = Wiring = 44 44 45 45 (% style="width:700px" %)