Changes for page LSS-ADA Board (Type-C)

Last modified by Eric Nantel on 2023/03/15 07:59

From version < 219.2 >

edited by Brahim Daouas
on 2019/03/04 09:52

To version < 219.3 >

edited by Brahim Daouas
on 2019/03/04 09:53

< >

Change comment: There is no comment for this version

Summary

Page properties

Content

@@ -75,10
          +75,10 @@
  Using the LSS Adapter Board is fairly simple and user-friendly. The configuration switch SW1 on the board allows the user to select one of the following three communication methods. A communication mode is chosen by sliding the switch to the desired position on the board. For example, for USB communication, slide the switch to "USB". The two XBEE to USB jumpers do NOT need to be in place in any communication mode except for the "USB Explorer" feature. The intended uses include:
--* Mini USB (ex: computer, laptop, Raspberry Pi)
  * Arduino microcontroller with shield compatibility (ex. Arduino Uno)
++* Mini USB (ex: computer, laptop, Raspberry Pi)
++* Wireless module with XBee footprint (Bluetooth Bee, WiFi Bee etc.)
  * TTL UART Microcontroller or FPGA control (5V) via Tx, Rx, GND pins
--* Wireless module with XBee footprint (Bluetooth Bee, WiFi Bee etc.)
  |(% colspan="2" style="width:300px" %)(((
  == Arduino ==