Changes for page LSS-ADA Board (Type-C)
Last modified by Eric Nantel on 2023/03/15 07:59
Change comment: There is no comment for this version
Summary
-
Page properties (1 modified, 0 added, 0 removed)
Details
- Page properties
-
- Content
-
... ... @@ -176,7 +176,7 @@ 176 176 177 177 (3) Both XBee to USB jumpers in place 178 178 179 -**XBee Explorer** 179 +**XBee Explorer Feature** 180 180 181 181 The XBee Rx pin and Tx pins are connected to the Arduino's digital pins 8 and 9 respectively. Therefore, the LSS Adapter Board can be also used as a USB XBee explorer board to communicate with and/or configure an XBee module via the FTDI chip. Note that this is the only mode where the XBEE to USB jumpers should be in place. All LSS servos are on the same bus and will receive the same communications taking place between the USB host and XBee module, therefore it is suggested to unplug all other devices (including servos) in this mode. 182 182 )))