Changes for page LSS-ADA Board (Type-C)

Last modified by Eric Nantel on 2023/03/15 07:59

From version < 223.3 >

edited by Brahim Daouas
on 2019/03/04 10:27

To version < 223.4 >

edited by Brahim Daouas
on 2019/03/04 10:33

< >

Change comment: There is no comment for this version

Summary

Page properties

Content

@@ -144,7
          +144,7 @@
  **Mounting**
--The four mounting holes on the LSS adapter line up with the mounting holes of a Raspberry Pi B+/A+/3, though it is important to note that the hole diameter of the mounting holes on a Raspberry Pi are 2.5mm, whereas the mounting hole diameter on the LSS Adapter is 3.10mm. As such, the standard M3 standoffs and screws which are part of the Lynxmotion SES V2 system cannot be used. Standoffs must be sufficiently high in order to clear all pins of the Raspberry Pi.
++The four mounting holes on the LSS adapter line up with the mounting holes of a Raspberry Pi B+/A+/3, though it is important to note that the hole diameter of the mounting holes on a Raspberry Pi are 2.75mm, whereas the mounting hole diameter on the LSS Adapter is 3.10mm. As such, the standard M3 standoffs and screws which are part of the Lynxmotion SES V2 system cannot be used. Standoffs must be sufficiently high in order to clear all pins of the Raspberry Pi.
  )))
  |(% colspan="2" style="width:300px" %)(((
  == XBee ==