Summary

• Page properties (1 modified, 0 added, 0 removed)

Details

Page properties

Content

...	...	@@ -34,11 +34,14 @@
34	34	(((
35	35	= Pinout =
36	36
37		-|(% rowspan="7" style="width:350px" %){{lightbox image="LSS-POWERHUB-TOP-PinOut.png"/}}|(% rowspan="7" style="width:350px" %){{lightbox image="LSS-POWERHUB-BOTTOM-PinOut.png"/}}|(% style="vertical-align:middle; width:35px" %)[[image:[email protected]]]|(% style="vertical-align:middle" %)(((
38		-**Vin / Separate Vin**: With the Vin jumper in place, all servos connected to the hub are powered via the same source (blue and red power lines become connected). With the Vin jumper removed, the connector marked with an asterisk * is decoupled from the other three servos (blue and red no longer share Vin), allowing them to be powered separately from the barrel connector or other source.
	37	+|(% rowspan="10" style="width:350px" %){{lightbox image="LSS-LED-PinOUt.png"/}}|(% style="vertical-align:middle; width:35px" %)[[image:[email protected]]]|(% style="vertical-align:middle" %)(((
	38	+**Positive LSS**:
39	39	)))
40		-|(% style="vertical-align:middle" %)[[image:[email protected]]]|(% style="vertical-align:middle" %)**Vin**: With the jumper in place, all servos connected to the power hub are powered via the same source. Refer to the Voltage section of the [[LSS - Specifications>>doc:lynxmotion-smart-servo.lss-specifications.WebHome]] page to understand which voltages are meant to be connected to this pin.
41		-|(% style="vertical-align:middle" %)[[image:[email protected]]]|(% style="vertical-align:middle" %)**Ground (G)**: This pin should be connected to both the communication source's ground, as well as that of the power source (principle of "common ground"). When the Vin jumper is removed, ground is kept common.
	40	+|(% style="vertical-align:middle" %)[[image:[email protected]]]|(% style="vertical-align:middle" %)**Positive Balance**:
	41	+|(% style="vertical-align:middle" %)[[image:[email protected]]]|(% style="vertical-align:middle" %)**Ground (G)**:
	42	+|(% style="vertical-align:middle" %)[[image:[email protected]]]|(% style="vertical-align:middle" %)
	43	+|(% style="vertical-align:middle" %)[[image:[email protected]||alt="SQUARE-Black.png"]]|(% style="vertical-align:middle" %)
	44	+|(% style="vertical-align:middle" %)[[image:[email protected]]]|(% style="vertical-align:middle" %)**Not Connected**
42	42	|(% style="vertical-align:middle" %)[[image:[email protected]]]|(% style="vertical-align:middle" %)**Servo Rx pin (Rx)**: In serial mode, this pin should be connected to the Tx pin of a TTL serial device.
43	43	|(% style="vertical-align:middle" %)[[image:[email protected]]]|(% style="vertical-align:middle" %)**Servo Tx pin (Tx)**: In serial mode, this pin should be connected to the Rx pin of a TTL serial device.
44	44