Changes for page LSS-PRO Configure IDs

Last modified by Coleman Benson on 2024/10/08 12:52

From version < 2.2 >

edited by Eric Nantel
on 2024/07/25 10:22

To version < 4.1 >

edited by Eric Nantel
on 2024/07/25 11:16

< >

Change comment: There is no comment for this version

Summary

Page properties

Content

@@ -1,45
          +1,35 @@
--
++= Step 1 - Connections =
++__Warning: Make sure your power supply is OFF and wait at least 10s before connecting to the LSS-P actuator.__
--|(% colspan="2" %)
--|(% style="width:30px" %) |
--|(% colspan="2" %)
--| |
--|(% colspan="2" %)
--| |
--| |
--| |
--| |
--| |
--| |
--| |
--| |
--| |
--| |
--| |
--| |
--| |
--| |
--| |
--| |
--| |
--| |
--| |
--| |
--| |
--| |
--| |
--| |
--| |
--| |
--| |
--| |
--| |
--| |
--| |
--| |
--| |
--| |
--| |
++* (((
++Connect the XT60 from your power supply
++)))
++* Connect the USB Type-C cable
--
++= Step 2 - Power-Up =
++
++* Proceed with powering the actuator
++
++= Step 3 - Software =
++
++* Install the LSS PRO Configuration software (HERE)
++* Open the LSS PRO Configuration software
++
++= Step 4 - Connection =
++
++* Select the COM port associated with your actuator
++* Click Connect
++
++= Step 5 - Selection =
++
++* In the drop-down menu, select your actuator
++
++= Step 6 - Set the ID =
++
++* In the "Configuration" drop-down menu, select "CID / ID Number"
++* In the text entry box, set the desired ID number
++* Click on the "Send" button
++* Click on the "Reset button
++
++At that point your Actuator should have the new ID configured.