Summary

• Page properties (1 modified, 0 added, 0 removed)

Details

Page properties

Content

...	...	@@ -1,19 +1,0 @@
1		-= Connecting via USB =
2		-
3		-1. Connect the USB cable to the LSS Adapter board on your robot
4		-1. Plug the USB connector into the PC
5		-1. Connect your LSS to the LSS-Adapter with the Lynxmotion cable
6		-1. Connect the power to the LSS Adapter via the yellow XT60 plug
7		-1. Power on the robot (On/Off switch)
8		-1. Start the LSS FlowArm software
9		-1. Select the type of LSS Arm you are using (3 DoF / 4 DoF / 5 DoF)
10		-1. It will automatically try to find the connected Arm but, if not, you can manually choose the appropriate COM port from the drop-down list & the baud rate (default is 115200)
11		-1. The software sends a query to servo ID1 and once a reply is received, it determines connection has been established and a green light will be displayed aside the COM port.
12		-
13		-== Calibration ==
14		-
15		-1. Go in "TEACH" mode with the button on the top bar.
16		-1. Manually place the arm in the correct position for your model and with the gripper closed.
17		-1. Store the values or Offsets by clicking "STORE OFFSETS"
18		-1. At that point the arm should "stay" in that position once released
19		-1. Exit the "TEACH" mode by clicking it again