LSS FlowArm - Setup
Version 42.1 by Eric Nantel on 2022/06/20 15:50
| Connecting via USB | ||||
| 1. Connect the USB cable to the Arm and PC & Power Adapter to the Arm XT60 | ||||
|
| |||
| 2. Power the arm using the power supply ON/OFF switch. | ||||
| 3. Start the LSS FlowArm software (available HERE) | ||||
| ||||
4. Select the type of LSS Arm you are using (3 DoF / 4 DoF / 5 DoF) It will automatically try to find the connected Arm but, if not, you can manually choose the appropriate COM port from the drop-down list & the baud rate (default is 115200) | ||||
| ||||
| 5. The software sends a query to servo ID1 and once a reply is received, it determines connection has been established and a green light will be displayed aside the COM port. | ||||
|
| |||
| Calibration (Store Offsets) | ||||
1. Go in "TEACH" mode with the button on the top bar. | ||||
| ||||
| 2. Manually place the arm in the correct position for your model and with the gripper closed. (see images bellow) | ||||
| 4DOF / 5DOF | 3DOF | |||
| ||||
| 3. Store the values or Offsets by clicking "STORE OFFSETS" | ||||
| 4.At that point the arm should "stay" in that position once released | ||||
| 5. Exit the "TEACH" mode by clicking it again | ||||
