Changes for page LSS Communication Protocol

Last modified by Eric Nantel on 2024/11/21 09:43

From version < 100.1 >

edited by Coleman Benson
on 2019/02/20 09:39

To version < 101.1 >

edited by Coleman Benson
on 2019/02/20 10:18

< >

Change comment: There is no comment for this version

Summary

Page properties

Content

@@ -458,7
          +458,7 @@
  ====== __18. First Position (Pulse) (**FP**)__ ======
--In certain cases, a user might want to have the servo move to a specific angle upon power up; we refer to this as "first position" (a.k.a. "initial position"). The factory default has no first position value stored in EEPROM and therefore upon power up, the servo remains limp until a position (or hold command) is assigned. FP and FD are different in that FP is used for RC mode only, whereas FD is used for smart mode only.
++In certain cases, a user might want to have the servo move to a specific angle upon power up; we refer to this as "first position" (a.k.a. "initial position"). The factory default has no first position value stored in EEPROM and therefore upon power up, the servo remains limp until a position (or hold command) is assigned. FP and FD are different in that FP is used for RC mode only, whereas FD is used for smart mode only. If a first position pulse is assigned, the servo will move to that angle and hold there for up to 2 seconds before going limp should a new pulse not be received.
  Query First Position in Pulses (**QFP**)