Summary

• Page properties (1 modified, 0 added, 0 removed)

Details

Page properties

Content

...	...	@@ -603,6 +603,8 @@
603	603
604	604	= Advanced =
605	605
	606	+The motion controller used in serial mode is not the same as the motion controller use in RC mode. RC mode is intended to add functionality to what would be considered "normal" RC behavior based on PWM input.
	607	+
606	606	====== __A1. Angular Stiffness (**AS**)__ ======
607	607
608	608	The servo's rigidity / angular stiffness can be thought of as (though not identical to) a damped spring in which the value affects the stiffness and embodies how much, and how quickly the servo tried keep the requested position against changes. There are no units.
...	...	@@ -633,7 +633,7 @@
633	633
634	634	====== __A2. Angular Holding Stiffness (**AH**)__ ======
635	635
636		-The angular holding stiffness determines the servo's ability to hold a desired position under load. The default value for stiffness depending on the firmware may be 0 or 1. Greater values produce increasingly erratic behavior and the effect becomes extreme below -4 and above +4. Maximum values are -10 to +10.
	638	+The angular holding stiffness determines the servo's ability to hold a desired position under load. The default value for stiffness depending on the firmware may be 0 or 1. Greater values produce increasingly erratic behavior and the effect becomes extreme below -4 and above +4. Maximum values are -10 to +10. Note that when  considering altering a stiffness value, the end effect depends on the mode being tested.
637	637
638	638	Ex: #5AH3<cr>
639	639
...	...	@@ -649,7 +649,7 @@
649	649
650	650	Ex: #5CAH2<cr>
651	651
652		-This writes the angular holding stiffness of servo #5 to 2 to EEPROM
	654	+This writes the angular holding stiffness of servo #5 to 2 to EEPROM. Note that when  considering altering a stiffness value, the end effect depends on the mode being tested.
653	653
654	654	====== __A3: Angular Acceleration (**AA**)__ ======
655	655