Summary

• Page properties (1 modified, 0 added, 0 removed)
• Attachments (0 modified, 1 added, 0 removed)
  • LSS - LED Patterns.png

Details

Page properties

Content

...	...	@@ -3,7 +3,7 @@
3	3
4	4	{{toc depth="3"/}}
5	5
6		-= Serial Protocol Concept =
	6	+= Serial Protocol =
7	7
8	8	The custom Lynxmotion Smart Servo (LSS) serial protocol was created in order to be as simple and straightforward as possible from a user perspective ("human readable format"), while at the same time compact and robust yet highly versatile. The protocol was based on Lynxmotion's SSC-32 RC servo controller and almost everything one might expect to be able to configure for a smart servo motor is available.
9	9
...	...	@@ -194,7 +194,7 @@
194	194	Blink while: 1=Limp; 2=Holding; 4=Accel; 8=Decel; 16=Free 32=Travel;
195	195	)))
196	196
197		-== Details ==
	197	+== Details - Basic ==
198	198
199	199	====== __1. Limp (**L**)__ ======
200	200
...	...	@@ -468,7 +468,7 @@
468	468
469	469	====== __19. First Position (Degrees)__ ======
470	470
471		-In certain cases, a user might want to have the servo move to a specific angle upon power up; we refer to this as "first position" (a.k.a. "initial position"). The factory default has no first position value stored in EEPROM and therefore upon power up, the servo remains limp until a position (or hold command) is assigned.
	471	+In certain cases, a user might want to have the servo move to a specific angle upon power up; we refer to this as "first position" (a.k.a. "initial position"). The factory default has no first position value stored in EEPROM and therefore upon power up, the servo remains limp until a position (or hold command) is assigned. Note that the number should be restricted to -1790 (-179.0 degrees) to +1790 (179.0 degrees) and values beyond this will be changed to 1800.
472	472
473	473	Query First Position in Degrees (**QFD**)
474	474
...	...	@@ -595,7 +595,7 @@
595	595
596	596	Note that after the CONFIRM command is sent, the servo will automatically perform a RESET.
597	597
598		-= Advanced =
	598	+== Details - Advanced ==
599	599
600	600	The motion controller used in serial mode is not the same as the motion controller use in RC mode. RC mode is intended to add functionality to what would be considered "normal" RC behavior based on PWM input.
601	601
...	...	@@ -706,3 +706,9 @@
706	706	Ex: #5CLB63<cr> blink in all status (1 + 2 + 4 + 8 + 16 + 32)
707	707
708	708	RESETTING the servo is needed.
	709	+
	710	+= RGB LED Patterns =
	711	+
	712	+The LED patterns below do not include those which are part of the button menu, which can be found here: [[LSS Button Menu>>doc:lynxmotion-smart-servo.lss-button-menu.WebHome]]
	713	+
	714	+[[image:LSS - LED Patterns.png]]

LSS - LED Patterns.png

Author

...	...	@@ -1,0 +1,1 @@
	1	+xwiki:XWiki.RB1

Size

...	...	@@ -1,0 +1,1 @@
	1	+116.3 KB

Content