Changes for page LSS Communication Protocol

Last modified by Eric Nantel on 2024/11/21 09:43

From version < 51.1 >

edited by RB1
on 2018/09/10 17:03

To version < 49.1 >

edited by RB1
on 2018/09/10 16:55

< >

Change comment: There is no comment for this version

Summary

Page properties

Content

@@ -522,16
          +522,10 @@
  The units are in milliamps, so in the example above, the servo is consuming 140mA, or 0.14A.
--__30. RC Mode (**CRC**)__
++__20. RC Mode (**CRC**)__
--This command puts the servo into RC mode (position or continuous), where it will only respond to RC pulses. Note that because this is the case, the servo will no longer accept serial commands. The servo can be placed back into smart mode by using the button menu.
++This command puts the servo into RC mode, where it will only respond to RC pulses. Note that because this is the case, the servo will no longer accept serial commands. The servo can be placed back into smart mode only using the button menu.
--|**Command sent**|**Note**
--|ex: #5CRC<cr>|Stay in smart mode.
--|ex: #5CRC1<cr>|Change to RC position mode.
--|ex: #5CRC2<cr>|Change to RC continuous (wheel) mode.
--|ex: #5CRC***<cr>**|Where *** is any number or value. Stay in smart mode.**
--
  EX: #5CRC<cr>
  __**RESET**__