Summary

• Page properties (1 modified, 0 added, 0 removed)

Details

Page properties

Content

...	...	@@ -39,7 +39,7 @@
39	39
40	40	Results in the servo rotating from the current angular position to a pulse position of 1456 in 1263 milliseconds.
41	41
42		-Modified commands are command specific.
	42	+Action modifiers can only be used with certain commands.
43	43	)))
44	44
45	45	(((
...	...	@@ -572,14 +572,19 @@
572	572
573	573	[[image:LSS-servo-positions.jpg]]
574	574
575		-Example: Gyre direction / rotation is positive (clockwise), and origin offset has not been modified.
	575	+Example: Gyre direction / rotation is positive (clockwise), and origin offset has not been modified. Each square represents 30 degrees.
576	576
577		-#1D-300<cr> The servo is commander to move to -30.0 degrees (green arrow)
	577	+#1D-300<cr> The servo is sent a command to move to -30.0 degrees (green arrow)
578	578
579	579	#1D2100<cr> This second position command is sent to the servo, which moves it to 210.0 degrees (orange arrow)
580	580
581		-#1D-4200<cr> The servo rotates counterclockwise to a position of -420 degrees (red arrow), which means one full rotation of 360 degrees and (420.0-360.0) stopping at an absolute position of 60.0 degrees, but virtual position of -420.0.
	581	+#1D-4200<cr> This next command rotates the servo counterclockwise to a position of -420 degrees (red arrow), which means one full rotation of 360 degrees,  stopping at an absolute position of 60.0 degrees (420.0-360.0), with a virtual position of -420.0 degrees.
582	582
583		-Although the final position would be the same as if the servo were commanded to move to -60.0 degrees, it is in fact at -420.0 degrees.
	583	+Although the final physical position would be the same as if the servo were commanded to move to -60.0 degrees, the servo is in fact at -420.0 degrees.
584	584
585		-#1D4800<cr> This new command is sent which would then cause the servo to rotate from -420.0 degrees to 480.0 degrees, which would be a total of 900 degrees of clockwise rotation, or 2.5 complete rotations.
	585	+#1D4800<cr> This new command is sent which would then cause the servo to rotate from -420.0 degrees to 480.0 degrees (blue arrow), which would be a total of 900 degrees of clockwise rotation, or 2.5 complete rotations.
	586	+
	587	+#1D3300<cr> would cause the servo to rotate from 480.0 degrees to 330.0 degrees (yellow arrow).
	588	+
	589	+
	590	+If / once the servo loses power or is power cycled, it also loses the virtual position associated with that session. For example, if the virtual position was 480.0 degrees before power is cycled, upon power up the servo's position will be read as +120.0 degrees from zero (assuming center position has not been modified).