Summary

• Page properties (1 modified, 0 added, 0 removed)

Details

Page properties

Content

...	...	@@ -444,6 +444,10 @@
444	444
445	445	Configuring the LED color via the CLED command sets the startup color of the servo after a reset or power cycle. Note that it also changes the session's LED color immediately as well.
446	446
	447	+====== __16b. Configure LED Blinking (**CLB**)__ ======
	448	+
	449	+???
	450	+
447	447	====== __17. Identification Number__ ======
448	448
449	449	A servo's identification number cannot be set "on the fly" and must be configured via the CID command described below. The factory default ID number for all servos is 0. Since smart servos are intended to be daisy chained, in order to respond differently from one another, the user must set different identification numbers. Servos with the same ID and baud rate will all receive and react to the same commands.