Summary

• Page properties (1 modified, 0 added, 0 removed)

Details

Page properties

Content

...	...	@@ -446,8 +446,18 @@
446	446
447	447	====== __16b. Configure LED Blinking (**CLB**)__ ======
448	448
449		-???
	449	+This command allows you to control when the RGB LED will blink the user set color (see [[H16b.RGBLED28LED29]]) for details).
	450	+You can turn on or off blinking for various LSS status. Here is the list and their associated value: 0=No blinking, Blink while: 1=Limp; 2=Holding 4=Accel; 8=Decel; 16=Free 32=Travel; 63=Always blink;
450	450
	452	+To set blinking, use CLB with the value of your choosing. To activate blinking in multiple status, simply add together the values of the corresponding status. See examples below:
	453	+
	454	+Ex: #5CLB0<cr> to turn off all blinking (LED always solid)
	455	+Ex: #5CLB1<cr> only blink when limp
	456	+Ex: #5CLB2<cr> only blink when holding
	457	+Ex: #5CLB12<cr> only blink when accel or decel
	458	+Ex: #5CLB48<cr> only blink when free or travel
	459	+Ex: #5CLB63<cr> blink in all status
	460	+
451	451	====== __17. Identification Number__ ======
452	452
453	453	A servo's identification number cannot be set "on the fly" and must be configured via the CID command described below. The factory default ID number for all servos is 0. Since smart servos are intended to be daisy chained, in order to respond differently from one another, the user must set different identification numbers. Servos with the same ID and baud rate will all receive and react to the same commands.