Wiki source code of LSS Config - Setting IDs
Version 18.1 by Eric Nantel on 2019/05/21 11:34
Hide last authors
 |
18.1 | 1 | = What's Needed = |
| |
17.1 | 2 | |
| 3 | (% style="max-width:750px" %) | ||
| |
18.1 | 4 | |(% colspan="6" %)**[[doc:servo-erector-set-system.WebHome]]** |
| 5 | |(% style="width:125px" %)LSS Servo|(% style="width:125px" %)LSS Adapter|(% style="width:125px" %)LSS Power|(% style="width:125px" %)USB Cable|(% style="width:125px" %) |(% style="width:125px" %) | ||
| 6 | |[[image:servo-erector-set-system.ses-servos.ses-lynxmotion-smart-servo.WebHome@LSS-Servo.PNG]]|[[image:servo-erector-set-system.ses-electronics.ses-modules.lss-adapter-board.WebHome@LSS-ADA.png]]|[[image:servo-erector-set-system.ses-electronics.ses-wall-adapters.WebHome@RB-Hap-05.png]]|[[image:servo-erector-set-system.ses-electronics.ses-wiring.WebHome@USB-Cable-A-Mini.PNG]]| | | ||
| |
17.1 | 7 | |
| |
2.1 | 8 | Material needed / suggested: |
| 9 | |||
| 10 | LSS Servo | ||
| 11 | |||
| 12 | LSS Adapter | ||
| 13 | |||
| 14 | LSS Power Supply | ||
| 15 | |||
| |
5.1 | 16 | USB Cable |
| |
2.1 | 17 | |
| |
5.1 | 18 | |
| |
16.1 | 19 | |(% style="width:350px" %){{lightbox image="LSS-Config-IDs-Switch.PNG"/}}|Set LSS Adapter to USB mode |
| 20 | |{{lightbox image="LSS-Config-IDs-USB-Power.PNG"/}}|Connect the Supply & USB to the Adapter | ||
| 21 | | |Connect your LSS Servo to the Adapter | ||
| 22 | | |Open the LSS Config | ||
| 23 | | |Connect | ||
| 24 | | |Set the servo ID & Update | ||
| 25 | | |Apply a post-it | ||
| 26 | | |Next servo / to Step 2 |