LSS - Electrical
Version 19.1 by Coleman Benson on 2019/02/20 09:39
Page Contents
Pinout
|  | Servo Rx pin: In serial mode, this pin should be connected to a 5V TTL serial pin. In RC mode, the pin should be connected to an 5V RC PWM pin |
 | Servo Vcc pin: Refer to the Voltage section of the LSS - Specifications page to understand which voltages are meant to be connected to this pin. | |
 | Ground (GND): This pin should be connected to both the communication sources' ground, as well as that of the power source (principle of "common ground"). | |
 | Servo Tx pin: In serial mode, this pin sends the output from query commands. In RC mode, the cable does not need to be connected as there is no output. |
Serial Wiring
| In order to daisy chain one servo to the next (serial mode only), rollover serial cables are used. Although the wires are straight, one connector is rotated 180 degrees with respect to the other. | ||
|
| |
RC Wiring | ||
| ||
Electronics | |
The electronics inside the servo include the following:
| |