Summary

• Page properties (2 modified, 0 added, 0 removed)

Details

Page properties

Tags

...	...	@@ -1,1 +1,1 @@
1		-LSS|RC|PWM|control|firmware|angle|position
	1	+LSS|RC|PWM|control|firmware|angle|position|LSS-Ref

Content

...	...	@@ -11,7 +11,7 @@
11	11
12	12	= LSS RC Mode =
13	13
14		-All three Lynxmotion Smart Servo motors can be used with normal hobby remote control (RC) electronics including remote controls and RC servo controllers. Unlike normal RC servo motors however, the LSS motor configuration can be changed via programming. The current method to change from serial to RC mode is via the [[LSS - Button Menu>>doc:Lynxmotion Smart Servos (LSS).LSS - Button Menu.WebHome||style="background-color: rgb(255, 255, 255);"]].
	14	+All three Lynxmotion Smart Servo motors can be used with normal hobby remote control (RC) electronics including remote controls and RC servo controllers. Unlike normal RC servo motors however, the LSS motor configuration can be changed via programming. The current method to change from serial to RC mode is via the [[LSS - Button Menu>>doc:Lynxmotion Smart Servo (LSS).LSS - Button Menu.WebHome||style="background-color: rgb(255, 255, 255);"]].
15	15
16	16	Note: Each modes can have the rotation reversed but clockwise is standard. (equivalent to CW1 or CW-1)
17	17
...	...	@@ -34,7 +34,7 @@
34	34
35	35	= Programmable Functionality =
36	36
37		-The functionality listed below applies to RC mode and can only via serial configuration commands. This means the servo must be connected to a computer (or other device like a microcontroller able to communicate serially) and the servo set to serial mode via the button menu. A detailed explanation of the commands can be found on the [[LSS - Communication Protocol>>doc:Lynxmotion Smart Servos (LSS).LSS - Communication Protocol.WebHome]] page. These configurations are saved within the servo and are retained even if the servo loses power.
	37	+The functionality listed below applies to RC mode and can only via serial configuration commands. This means the servo must be connected to a computer (or other device like a microcontroller able to communicate serially) and the servo set to serial mode via the button menu. A detailed explanation of the commands can be found on the [[LSS - Communication Protocol>>doc:Lynxmotion Smart Servo (LSS).LSS - Communication Protocol.WebHome]] page. These configurations are saved within the servo and are retained even if the servo loses power.
38	38
39	39	**Config. Origin Offset**: This command allows you to change the origin of the servo in relation to the factory zero position. The servo is shipped with the zero being centered on the side of the servo with the LED bar (image below)
40	40