Summary

• Page properties (1 modified, 0 added, 0 removed)

Details

Page properties

Content

...	...	@@ -43,7 +43,7 @@
43	43
44	44	{{lightbox image="lynxmotion-smart-servo.lss-configuration-software.WebHome@lss-config-20.7.14.2-scan-options.png" title="LSS Config - 20.7.14.2 - Scan options" width="124"/}}
45	45
46		-The next step once the COM port has been selected is to scan the port. The software can send commands to (and listen for a reply from) all servo IDs (0 to 250) at all standard baud rates on the selected COM port. In the pop-up, select the baud rates which you would like to scan. You may also limit the IDs to scan for. When in doubt, leave all baud rates selected
	46	+The next step once the COM port has been selected is to scan the port. The software can send commands to (and listen for a reply from) all servo IDs (0 to 250) at all standard baud rates on the selected COM port. In the pop-up, select the baud rates which you would like to scan. You press the **ALL** button to select all baud rates, press the individual check boxes to toggle each select or press the **<<** button to select only the corresponding baud rate, deselecting all others. You may also limit the IDs to scan for. When in doubt, leave all baud rates selected.
47	47
48	48	Once you press OK, the scan will start by turning off the LED of all servos on the selected baud rates (#254LED0\r). Then, each selected baud rate is scanned for servos. The command line interface will include messages for all servos found (or not found) at each baud rate, as well as any conflicts discovered (two or more LSS at the same location). In this case, a location is defined as a baud rate and ID pair.
49	49