LSS Origin Offset
Last modified by Eric Nantel on 2024/04/04 09:43
| This tutorial is used to do a Configuration of Origin Offset on a series of LSS all at once and using the LSS-Config software. One can achieve the same result with any serial terminal using the "CO" command. | |
1. Set the LSS Adapter to "USB" serial communication | |
| |
| 2. Connect the USB cable & Power to the LSS Adapter | |
|
|
| 3. Open the LSS configuration software (download HERE) | |
| |
| 4. Set your COM port, Connect & Scan for servos | |
|
|
| 5. In the servo selection click on "LSS-ALL (254; ---k)" | |
| |
| 6. Locate the "Terminal" text input | |
| |
| 7. Type the following command between quotation marks "CO" for Configure Origin offset. Press "ENTER" to send the command | |
| |
| 8. If you did it correctly, the terminal should display every scanned servo with a "CO" command | |
| |
| 9. To verify if the command have been received by the servo, select one servo only | |
| |
| 10. Look at the "Position" value and it should be "0" or very close | |
| |
| Note: Confirm the "Origin Offset" on multiple servos to be safe | |
