Last modified by Eric Nantel on 2021/09/24 09:36
From version < 283.1 >
edited by Eric Nantel
on 2018/06/20 13:53
To version < 283.2 >
edited by Brahim Daouas
on 2018/06/20 13:56
< >
Change comment: There is no comment for this version

Summary

Details

Page properties
Author
... ... @@ -1,1 +1,1 @@
1 -xwiki:XWiki.ENantel
1 +xwiki:XWiki.BDaouas
Content
... ... @@ -33,7 +33,7 @@
33 33  
34 34  1. DO NOT connect the batteries until everything has been wired and checked.
35 35  1. Verify the polarity of the battery connector(s) and sure the positive (red) lead connects to the top PCB, and the negative / GND (black) lead connects to the bottom PCB.
36 -1. Should your ESC not use the correct bullet connectors for power, the existing connectors can be removed and replaced by 3.5mm connectors. Ensure the type of connector is used before soldering (see image below).
36 +1. Should your ESC not use the correct bullet connectors for power, the existing connectors can be removed and replaced by 3.5mm connectors.
37 37  1. Connect the ESCs to the PDB based on the configurations below, ensuring the positive is connected to the top place and negative connected to the bottom plate. 
38 38  11. For a single battery configuration, the ESCs should be installed close to the battery
39 39  11. For a dual battery configuration, the ESCs should be installed equally on the board to try to lessen uneven current draw between the batteries
Copyright RobotShop 2018