Changes for page LSS-2MC Board
Last modified by Eric Nantel on 2023/05/29 07:33
Change comment: There is no comment for this version
Summary
-
Page properties (1 modified, 0 added, 0 removed)
Details
- Page properties
-
- Content
-
... ... @@ -59,11 +59,14 @@ 59 59 |(% colspan="2" rowspan="1" %)**Pin D2: **H-Bridge NSleep (set high to enable) 60 60 |(% colspan="2" rowspan="1" %)**Pin D8:** H-Bridge NFault 61 61 62 -(% style="color:inherit; font-family:inherit; font-size:29px" %)Power 62 +|(% colspan="3" style="width:300px" %)**Power** 63 +|(% colspan="1" rowspan="2" style="width:300px" %){{lightbox image="LSS-2MC-Power.png"/}}|(% style="vertical-align:middle; width:35px" %)[[image:[email protected]]]|(% style="vertical-align:middle" %)((( 64 +**LSS Connectors: **The board is meant to be powered from ONE of the two LSS connectors. Vin will supply the two on-board 5V regulators (logic and Vout) and to the Lynxmotion Smart Servos connected on the bus. Power will also be supplied to the h-bridge at the same voltage as the bus voltage. 63 63 64 -|(% colspan="1" rowspan="2" style="width:300px" %){{lightbox image="LSS-2MC-Power.png"/}}|(% style="vertical-align:middle; width:35px" %)[[image:[email protected]]]|(% style="vertical-align:middle" %)**LSS Connectors: **The board is meant to be powered from ONE of the two LSS connectors. Vin will supply the two on-board 5V regulators (logic and Vout) and to the Lynxmotion Smart Servos connected on the bus. Power will also be supplied to the motor controller at the same voltage as the bus voltage. Refer to LSS Voltage rating in [[LSS - Specifications>>doc:lynxmotion-smart-servo.lss-specifications.WebHome||rel="noopener noreferrer" target="_blank"]] 66 +Refer to LSS Voltage rating in [[LSS - Specifications>>doc:lynxmotion-smart-servo.lss-specifications.WebHome||rel="noopener noreferrer" target="_blank"]] 67 +))) 65 65 |(% style="vertical-align:middle; width:35px" %)[[image:[email protected]||alt="SQUARE-Red.png"]]|(% style="vertical-align:middle" %)((( 66 -**USB: **Connecting only the USB will only provide voltage to the logic. It won't power the Voutrail nor otherLSSconnected on the bus.69 +**USB: **Connecting only the USB will only provide voltage to the logic. It won't power the h-bridge chip. 67 67 ))) 68 68 |(% colspan="3" style="width:300px" %)~*~*NOTE:~*~* USB and Vin power source are isolated and there are no issues connecting both a USB and a powered LSS bus at the same time 69 69