Changes for page LSS-ADA Board (Type-C)

Last modified by Eric Nantel on 2023/03/15 07:59

From version < 223.10 >

edited by Brahim Daouas
on 2019/03/04 10:41

To version < 223.11 >

edited by Brahim Daouas
on 2019/03/04 10:42

< >

Change comment: There is no comment for this version

Summary

Page properties

Content

@@ -90,7
          +90,7 @@
  |(% style="width:300px" %){{lightbox image="LSS-ADAPTER-Arduino.png"/}}|(((
  **Hardware Serial**
--To use the LSS Adapter Board with an Arduino microcontroller board, the mode selection switch SW1 should be in place to "Arduino". This configuration allows communication with the LSS actuators from an Arduino Board and can be used to build autonomous or semi-autonomous robots. When "Arduino" is selected on the communication switch:
++To use the LSS Adapter Board with an Arduino microcontroller board, the mode selection switch SW1 should be set to "Arduino". This configuration allows communication with the LSS actuators from an Arduino Board and can be used to build autonomous or semi-autonomous robots. When "Arduino" is selected on the communication switch:
  * Arduino's Rx (digital 0) <-> LSS actuator's Tx pin
  * Arduino Tx (digital 1) <-> LSS actuator's Rx pin