Summary

• Page properties (1 modified, 0 added, 0 removed)

Details

Page properties

Content

...	...	@@ -30,7 +30,9 @@
30	30
31	31	= Pinout & Wiring =
32	32
33		-|(% rowspan="4" style="width:350px" %){{lightbox image="LSS-ADAPTER-PinOut.png"/}}|(% style="text-align:center; vertical-align:middle; width:35px" %)[[image:Lyxnmotion [email protected]]]|**Servo Vcc pin**: Refer to the Voltage section of the [[LSS - Specifications>>doc:Lynxmotion Smart Servo (LSS).LSS - Specifications.WebHome]] page to understand which voltages are meant to be connected to this pin. VCC pins on all six connectors, including the XT60 VCC and the V (red dot in the image at left) pin are connected together.
	33	+|(% rowspan="4" style="width:350px" %){{lightbox image="LSS-ADAPTER-PinOut.png"/}}|(% style="text-align:center; vertical-align:middle; width:35px" %)[[image:Lyxnmotion [email protected]]]|(((
	34	+**Servo Vin**: Refer to the Voltage section of the [[LSS - Specifications>>doc:Lynxmotion Smart Servo (LSS).LSS - Specifications.WebHome]] page for more information on the LSS operating voltage. Vin pins on all six connectors, including the XT60 Vin and the V (red dot in the image at left) pin are connected together.
	35	+)))
34	34	|(% style="text-align:center; vertical-align:middle" %)[[image:Lyxnmotion [email protected]]]|**Ground (GND)**: This pin should be connected to both the communication sources' ground, as well as that of the power source (principle of "common ground"). GND pins on all connectors, including the XT60 GND and two GND pins are corrected together.
35	35	|(% style="text-align:center; vertical-align:middle" %)[[image:Lyxnmotion [email protected]]]|**Servo Rx pin**: In serial mode, this pin should be connected to the servo's Rx serial pin. If you are using the Lynxmotion serial cables, simply plug in the servo to the LSS adapter.
36	36	|(% style="text-align:center; vertical-align:middle" %)[[image:Lyxnmotion [email protected]]]|**Servo Tx pin**: In serial mode, this pin should be connected to the servo's Tx serial pin. If you are using the Lynxmotion serial cables, simply plug in the servo to the LSS adapter.