Changes for page LSS-ADA Board (USB Mini)

Last modified by Eric Nantel on 2023/03/15 07:59

From version < 223.15 >

edited by Brahim Daouas
on 2019/03/04 10:44

To version < 223.16 >

edited by Brahim Daouas
on 2019/03/04 10:45

< >

Change comment: There is no comment for this version

Summary

Page properties

Content

@@ -176,7
          +176,7 @@
  (3) Both XBee to USB jumpers in place
--**XBee Explorer**
++**XBee Explorer Feature**
  The XBee Rx pin and Tx pins are connected to the Arduino's digital pins 8 and 9 respectively. Therefore, the LSS Adapter Board can be also used as a USB XBee explorer board to communicate with and/or configure an XBee module via the FTDI chip. Note that this is the only mode where the XBEE to USB jumpers should be in place. All LSS servos are on the same bus and will receive the same communications taking place between the USB host and XBee module, therefore it is suggested to unplug all other devices (including servos) in this mode.
  )))