Changes for page LSS-ADA Board (USB Mini)

Last modified by Eric Nantel on 2023/03/15 07:59
From version < 235.1 >
edited by Eric Nantel
on 2019/05/06 15:08
To version < 236.1 >
edited by Coleman Benson
on 2019/05/09 16:39
< >
Change comment: There is no comment for this version

Summary

Details

Page properties
Author
... ... @@ -1,1 +1,1 @@
1 -xwiki:XWiki.ENantel
1 +xwiki:XWiki.CBenson
Content
... ... @@ -100,6 +100,8 @@
100 100  
101 101  This way, the Arduino communicates with the LSS actuator through the LSS Adapter Board. Note that the Arduino's GND pins are all connected to the LSS Adapter's GND. The XBEE-USB jumpers do NOT need to be in place.
102 102  
103 +If you want to upload new code to the Arduino board while it is connected to the LSS Adapter, set the switch to USB.
104 +
103 103  **Software Serial**
104 104  
105 105  Arduino digital pins 8 and 9 are also connected on the board in order to use [[software serial>>https://www.arduino.cc/en/Reference/SoftwareSerial]]. This allows the Arduino to communicate with both the LSS servos which are connected to the LSS adapter, as well as an external module connected to the Bee socket. Should no Bee module be connected, the software serial pins can still be used when the switch is placed in "XBee" mode :
Copyright RobotShop 2018