Changes for page LSS-LED Board

Last modified by Eric Nantel on 2023/03/15 07:58

From version < 23.1 >

edited by Eric Nantel
on 2022/06/29 08:02

To version < 24.1 >

edited by Eric Nantel
on 2022/06/30 13:13

< >

Change comment: There is no comment for this version

Summary

Page properties

Content

@@ -8,7
          +8,7 @@
  = Description =
--The Lynxmotion (LSS) - LED module is intended to add lighting to your servo erector set (SES) v2 project. The module is meant to be connected to the standard mounting of an Lynxmotion Smart Servo (LSS) Motor and can be added to the serial bus. Like the LSS which can be operated over a range of input voltages, this LED module is meant to operate between 6.4V and 18V. The module can be powered one of  two ways where the onboard switch selects which of the two sources powers the LED:
++The Lynxmotion (LSS) - LED module is intended to add lighting to your servo erector set (SES) v2 project. The module is meant to be connected to the standard mounting of an Lynxmotion Smart Servo (LSS) Motor and can be added to the serial bus. Like the LSS which can be operated over a range of input voltages, this LED module is meant to operate between 6V and 12V. The module can be powered one of  two ways where the onboard switch selects which of the two sources powers the LED:
  * Option 1: Four-pin LSS bus (Tx, GND, 12V, Rx)
  * Option 2: Four-pin, three cell Lithium balance port (3 individual cells = 11.1V)