Changes for page LSS-ADA Board (Type-C)

Last modified by Eric Nantel on 2023/03/15 07:59

From version < 225.2 >

edited by Brahim Daouas
on 2019/03/04 10:51

To version < 225.3 >

edited by Brahim Daouas
on 2019/03/04 11:20

< >

Change comment: There is no comment for this version

Summary

Page properties

Content

@@ -180,7
          +180,7 @@
  The LSS Adapter Board can be also used as a USB XBee explorer board to communicate with and/or configure an XBee module via the FTDI chip. The switch should be set to "USB" mode. Note that this is the only mode where the XBEE to USB jumpers should be in place. All LSS servos are on the same bus and will receive the same communications taking place between the USB host and XBee module, therefore it is suggested to unplug all other devices (including servos) in this mode.
--**RSSI LED : **
++**RSSI LED : this** Led lights every time the connected XBee module receives data. Its intensity represents the RSSI value of the last-received data: a brighter light means a higher RSSI value and better signal quality.
  )))
  = Dimensions =