Changes for page LSS-ADA Board (USB Mini)

Last modified by Eric Nantel on 2023/03/15 07:59

From version < 223.9 >

edited by Brahim Daouas
on 2019/03/04 10:41

To version < 223.10 >

edited by Brahim Daouas
on 2019/03/04 10:41

< >

Change comment: There is no comment for this version

Summary

Page properties

Content

@@ -128,7
          +128,7 @@
  (2) Mini USB connected to a USB device
--To use the LSS Adapter Board with a standard computer, laptop or Raspberry Pi through USB, the switch should be set to "USB" mode. This configuration allows communication with the LSS actuators by sending serial commands from a USB host device via the FTDI chip. When USB is selected on the communication switch, the FTDI Rx is connected to the LSS actuator's Tx and FTDI Tx is connected to the LSS actuator's Rx. The XBEE-USB jumpers do NOT need to be in place.
++To use the LSS Adapter Board with a standard computer, laptop or Raspberry Pi through USB, the switch SW1 should be set to "USB" mode. This configuration allows communication with the LSS actuators by sending serial commands from a USB host device via the FTDI chip. When USB is selected on the communication switch, the FTDI Rx is connected to the LSS actuator's Tx and FTDI Tx is connected to the LSS actuator's Rx. The XBEE-USB jumpers do NOT need to be in place.
  As such, the LSS Adapter is also compatible with a Raspberry Pi using the USB connector. The switch needs to be set to USB mode, and the Mini USB connected to one of the Raspberry Pi's USB ports.